A report can be produced about any vessel that you defined, if the points of interest (bookmarks and/or stenosis) are defined for it.
1. To view the report, click Preview Report 
in the toolbar.
The report provides you with the measurements for the points of interest, including:
Minimum Diameter
Maximum Diameter
Mean Diameter
Area of stenosis/bookmark
Length of stenosis/bookmark
NOTE: The contour displayed on the image is calculated automatically. The mean, minimum, and maximum diameters, and the area calculated are estimates, indicated on the image by the suffix est.
These measurements should not be used for diagnosis. To approve the measurements, or to approve the new values after editing the contour, right-click the measurement annotation, then click Approved.
2. Enter comments in the right pane, if desired
3. Select one of the following report options:
Preview Report: Displays the Preview Report window in which you can preview the entire report, including your comments and any images in the study that were marked as key images. From the Preview window:
Click Save to save the report.
Click Print to print the report.
Click Cancel to close the Preview Report window.
Save Report: Saves the report. A message appears at the bottom of the window to indicate that the report was saved successfully.
Close: Closes the report in progress window without saving.