The Viewer supports a maximum of two states, representing the beginning and end of the Cine movie. When two states are defined, the Cine movie runs only between the first and last image set (and not the entire group), regardless of whether or not the last image set is the last image within the group.
NOTE: From the Viewer, you can only set two states for a Cine option. When viewing images in MPR and Angiography MIP, you can set more than two states. See Applying States to Cine Movies and Viewing Cine Movies.
1. Select a group of images.
Make sure you are viewing the first image of the desired Cine movie.
2. Make any necessary changes to the image.
You can zoom, pan, swivel, rotate, and adjust the window/level.
3. If no Cine movie was previously defined, click Set State 
to set the current view of the image to the initial Cine state.
NOTE: If a previous Cine movie was defined, click New Cine 
and set the state of the new Cine.
4. Go to the second presentation of the movie and click Set State again.
5. Change the zoom, pan, swivel, rotate, and window/level parameters between each state, if desired.
6. After you have defined all states, click Play 
.
7. Click OK.
The Cine movie plays. You can change the Frame Rate to increase or reduce the speed of the movie.