You can mark one central image, and the system expands the selection to several mm or images in each side.
Important: Mark Slab by Center is unavailable for non-volumetric data, such as CR, DR, XR, MG, US or in localizer images.
NOTE: The system creates a slab with a symmetric number of images or equal thickness from each side of the middle slab image. The system automatically adjusts the calculation to create a symmetric sub-volume around the center image as needed.
Important: Finish the marking process before you apply annotations or measurements, or manipulate the image. If you change the cursor mode before you mark the final image, you will cancel the marking process prematurely.
1. In the main menu, click File --> Mark Significant Series --> Mark Slab by Center. The cursor changes to a circle.
2. Click the center (middle) of the image. A window opens.
3. In the window, select one of the following options and input a value:
Total length of slab in millimeters
Total number of images in slab
4. Click OK.
1. Change to an MPR Rendition or use the MPR viewbox application.
2. Right-click the image. From the drop-down menu, select Export Series --> Mark Slab by Center. The cursor changes to a circle.
3. Click the center (middle) of the image. A window opens.
4. In the window, select one of the following options and input a value:
Total length of slab in millimeters
Total number of images in slab
5. Click OK.
See these topics: